Do NOT recommend. Measurements are critical. If the measurements are wrong then it will all be wrong!! They measured wrong!! Went to them for granite counters, backsplash, and a cap on the pass-thru between kitchen/living area. Heaven forbid if I'd had a large kitchen with a big island but this was a basic small L-shape kitchen with a pass-thru.
SHORT STORY......
1) Measured wrong so cuts were wrong
2) Unprofessional owners and office staff (yet great installers!)
3) Don't go. Just don't. Save yourself the mess, time, and stress
LONG STORY............
They measured wrong so of course the granite was cut wrong for the backsplash and for the pass-thru. One end of the backsplash was cut correct, the other end was cut short. Same with the pass-thru cap, one corner was cut correct, 3 corners were cut short. Their answer to that mess? To cut the correct end of the backsplash to match the short end and to cut the one correct corner of the pass-thru cap to match the three mis-cut corners. Really!?!? So the thought apparently was that I should be happy all would match and just ignore that they would all be wrong!!!
So the guy comes back out to re-measure and so they can re-cut the backsplash and pass-thru cap. Have to say I've dealt with AHs in my time but will be dammed if the AH will come into my house and act like an AH. So he's throwing a tantrum to show me just how put-out he is, but he re-measured, sort-of, slap here-slap there, done in 3-4 minutes. I thought there is no way this is going to be correct.
So the guys come back out to install the re-cut backsplash and pass-thru cap. They bring in the backsplash and of course it's not right. I asked and was assured they would be cutting the 2 new pieces from the same slab but of course the new pieces didn't match!!! I know the different flow to granite but I also know the difference between tan and grey!!! And it wasn't "well it's just because you know the pieces were re-cut". The mis-match was slap-you-in-the-face obvious from across the room mis-match. Even the installers could see it although they couldn't say they gave the "yea it's bad" look!! Of course the re-cut pass-thru cap never made it off the truck. I really believe they used some left-over ends for the new cuts despite their assurances that they were cut from the same slab. I just say "no way".
So I call and speak to the guy again who told me several times "he's wasted enough time on this". Says that they came back out and re-measured "at my request". That they re-cut "at my request". Absolutely astounding!!! Considering THEY mis-measured and mis-cut. So I tell them to tear it out, give me my money back, we'll just call it quits, and I'd find a company that can do the work. So the workmen tore out the counters and I picked up a check the following Monday morning. And I did find a company who not only "could do the work" but are professionals who did accurate, precise work, and never once told me "they'd wasted enough time". read more