Cancel

    Search

    Legacy Plumbing & Heating

    5.0 (2 reviews)
    Open 7:00 am - 6:00 pm

    Get pricing & availability

    Response time

    2 hours

    Response rate

    100%

    Services - Legacy Plumbing & Heating

    Bathtub installation

    Bathtub repair

    Drain installation

    27 More Services

    Drain repair

    Faucet installation

    Faucet repair

    Gas line installation

    Gas line repair

    Hot water recirculation pump installation

    Hot water recirculation pump repair

    HVAC installation or replacement

    HVAC system repair

    HVAC system maintenance

    Plumbing inspection

    Plumbing installation or replacement

    Plumbing repair

    Sewer installation

    Sewer repair

    Shower installation

    Shower repair

    Sink installation

    Sink repair

    Sump pump installation

    Sump pump repair

    Toilet installation

    Toilet repair

    Water heater installation

    Water heater repair

    Water pipe installation

    Water pipe repair

    Legacy Plumbing & Heating Photos

    You might also consider

    Recommended Reviews - Legacy Plumbing & Heating

    Your trust is our priority, so businesses can't pay to alter or remove their reviews. Learn more about reviews.
    Yelp app icon
    Browse more easily on the app
    Review Feed Illustration

    2 years ago

    Helpful 0
    Thanks 0
    Love this 0
    Oh no 0

    2 years ago

    Helpful 0
    Thanks 0
    Love this 0
    Oh no 0

    Ask the Community - Legacy Plumbing & Heating

    You might also consider

    Verify this business for free

    People searched for Plumbing 24,468 times last month within 25 miles of this business.

    Verify this business

    Amerikhomes Heating & AC

    Amerikhomes Heating & AC

    (111 reviews)

    Jamaica

    I renovated my home and decided I didn't want a steam boiler and individual large air conditioners…read morealong with steam radiators for heat but still needed both Heat and Cooling. I contacted Amerikhomes and made an appointment for Leon to swing by to get an opinion on a new system. He came on time and recommended a mini split system as the solution which would be my primary source for both heating and cooling. We agreed on a system and moved forward with the installation. He ran the piping/wiring and drainage for the units in each room but didn't mount the units until the sheetrock was up. Once the sheetrock was up, he mounted the units and brazed the piping. He advised fittings was not the way to go because as time passes, it may produce a leak and because all the piping is inside the wall, it'll be very difficult to get to whereas brazing is more a permanent connection so he sealed each location via brazing. This was not a 1 time visit. The installation required a multitude of visits to complete. Once everything was installed and ready to be powered on, we went ahead and briefly tested it. The A/C was blowing ice cold and the Heat was nice and warm. No issues during the summer with the A/C but when winter came, a serious problem started to occur. In heat mode, the defrost came on which in itself is not unusual but what was is the fact that it would not turn off. The defrost cycle continued to run to the point where the inside units would start building up frost and ice and the only way for the unit to start heating up again was if you turned off all the indoor units and turned them back on. I contacted Leon to inform him and he couldn't find any issues with his work and that it has to be the unit. Justifiably, he will have to charge me to troubleshoot the unit to pinpoint the problem. For months, Leon and the vendor went back and fourth pointing out the possible causes for the issue but the vendor continued blaming Leon's work and Leon kept explaining that the issue was with the unit so they would not pay him to troubleshoot the unit itself. At this point, we were at the "tail end" of winter and ended up putting up with powering down all the units and powering them back on when the defrost issue started. It took months back and fourth with the vendor and manufacturer that winter had already passed and heat was no longer needed. Towards the end of summer I decided to take matters into my own hands and go based on what Leon mentioned to me being possible causes. he told me that it could be one of 3 things. Either a bad thermistor, a bad controller board or not enough Freon. Well, I know the charge was good because Leon had tested the unit countless times in front of me and the PSI was the same each time. I started with the cheapest item which was to purchase 3 thermistors. Tested each new thermistor and swapped them out. Upon testing the old ones, I found them to be functioning correctly but decided to leave the new ones in place anyways. Well... If the Thermistors were good and the PSI was within range, then the only other item according to Leon is the Controller board but would have to pay out of pocket since the manufacturer would not take responsibility and would charge me $678.00 for the controller. Keep in mind that i already spent thousands on the unit and the installation just to spend spend loads more on an expensive part for a brand new unit less than 1 year old. I refuse to further fund the manufacturer and decided to get the part on my own. I found a controller board from china for less than half the cost the manufacturer charged me. The part arrived ~ 3 weeks after I purchased it and went ahead that same day to swap it out. I took pictures of each part to make sure I put everything in the right place once disassembled. Long story short, I completed the swap. Also had to "de-bug" the system for it to recognize the indoor units. The whole process took me a good 3 hours. It was not cold enough to test because the temps outside were in the mid 60's so I had to wait until it got colder to turn the heat on. 3 weeks have passed where the heat needed to be used and finally started using the heater. After crossing my fingers, the unit, after 4 hours of being ran went into defrost (as it should) but came out of it as it supposed to do. It has been 3 months and not a single time did the defrost get stuck. LEON WAS RIGHT! Despite not charging me for the work/advice, he gave me the information to figure out what the problems could be. I have to say Leon was excessively patient during this whole headache and charged me not a penny more than the cost for the installation. Most installers would have said "everything on my end is good. Good luck dealing with the manufacturer" but Leon stuck around through the rough patches. He is fair on price, knowledgeable and patient. I will always use him for future reference anything HVAC related... I advise/recommend you to do the same.

    Excellent service. He was the only one that message back with pricing and time availability. When I…read morecalled to schedule, I explained what was wrong with my boiler and again explained to me his pricing and he said he should be able to fix it in a reasonable amount of time. He asked if I had any heat and I said "no" and he said he would be able to come later in the evening which was beyond his business hours. He said he would call when he was on his way and once he got here he went straight to work. Very knowledgeable and has a pleasant demeanor as well as decent pricing.

    Maxwell Plumb Mechanical - New 3" and 1" backflows. Another hard day's work that was well done!

    Maxwell Plumb Mechanical

    (21 reviews)

    Bayside

    I've used Maxwell Plumb Mechanical (MPM) over the past 12 years for my needs in the property…read moremanagement industry. Most recently, I had the opportunity to try them for my own needs as a homeowner. More specifically, I bought a two family home with two boilers that last looked to have been serviced in 2013, and the home inspection picked up several areas of concern with respect to the boilers. Jose showed up on or before schedule over the course of two days with two different helpers (Khalif & Jesus) and they all worked efficiently and thoroughly to leave both boilers in top form before leaving the job site for the last time today. As someone with a mechanical engineering background, I have been and remain impressed with the quality and care of their work. I am pleased to recommend them to any building owner or home owner who may need the services of a qualified plumbing/heating/mechanical contractor. A special thanks goes to Anita who coordinated the job and kept me in the loop every step of the way. Keep up the great work MPM!

    We have used Maxwell Plumbing exclusively for our plumbing needs in NYC. They came recommended by…read morethe building superintendent, and they are very professional and competent. Most recently, we had a problem with a very high-end imported shower, and it was next to impossible to find the cartridge needed to fix it. Lauren Scafidi went above and beyond to track down the elusive part, with cheerful tenacity, thus avoiding major inconvenience in replacing the entire fixture, breaking and repairing tiles, and a considerably longer time commitment. She is truly an asset to the company, and a pleasure to work with.

    Legacy Plumbing & Heating - plumbing - Updated May 2026

    Loading...
    Loading...
    Loading...