Slow, damaged the metal and poor-quality power coat. I took two sheet metal cabinets to get powder coated. Told me there may be some warpage on the lid but they could do it in three weeks. Three weeks go by, I call and they say it will be another couple of weeks. Stated they had to strip it again because they powder coated the hinge shut. Six weeks from the beginning they call and say it is done. They showed me the now bent up warped and dented cabinets. I asked them if they were proud of the work? They said no. They blamed the sand blaster. Told them the cabinets were useless to me. They said there was no charge. Gee thanks now I'm out two custom metal cabinets from an antique RV. Not only did they bent the metal they also bend the flanges that hold the hinges and several double thickness edges. Then they powder coater over the bent-up metal. Bubbled up dirty powder coating looks like it was coated over sand paper it is so rough. Maybe they can coat a fence post but they should not try sheet metal. read more