Total hack jobs. They also go by the name of Karves Custom Welding. Do not trust these people with…read moreany automotive related inquiries. They claim to have the experience and know how, yet the quality of the job looks less than the skills of what an apprentice would have. I brought in my vehicle to have panel replacement and dent removal done on it. Not only did they not remove the dents, but they also did not properly install the panels correctly... almost every panel they put on was at an angle or improperly placed onto the vehicle. They cut into a perfectly good intact panel with an angle grinder and initially played dumb like they had no clue how that had gotten there. Also used scrap metal (of different gauge) from what seemed to be lying on the ground outside of their shop, and now there is an infectious rust spot welded onto the side of my vehicle. If this isn't enough, then it's worth mentioning they clearly do not do quality checks either... went to do a once over on the vehicle when I arrived and not even 2 minutes in, I see a clamp holding a new panel onto the vehicle (un-fabbed). I am also able to wiggle some of the areas they "welded". The office is littered with THC related products... so unsure as to whether this incident is a lack of skill or the inability to stay sober at work...likely both. At this point, I'm going to have to spend twice as much as what I paid them just to have a true professional fix the areas, which should have properly been worked on and done the first time. The only reason I do not take both Mike and Nick to court is because of the rebuttal that they "did the job". Yes the job was done - but only partially and at the worst possible level of quality. Service Requested - partially completed Quality - unacceptable Value - diminished

Mike was hired to install an electrical panel for my rental unit. He completed the job but not to…read morethe job specs and refused to refund me the difference from the work completed and the agreed upon solution. He charged me 600 dollars for an electrical panel cover in which he just cut a piece of metal and applied magnets to the back. He assured me he would go back to complete the job as agreed upon (with a functioning door panel) but then advised he would not complete the job. He is very unprofessional and unreliable. I would look elsewhere if you're wanting professionalism and quality work. Highly advise against using this company and Mike in specific