My 19 yr old nephew bought a vehicle from SHEPHERDS and the first issue was after they "sold" it,…read morethe financing terms were amended a couple of times. Of course rates increased significantly. Within 6 months the vehicle stopped & had to be towed in. Unfortunately the EXTENDED WARRANTY he paid for, did not cover the problem. shepherds offered to fix for $800.0. Fortunately it was repaired in Logansport for a Whopping $88.00. My dad has always paid cash for his cars, at Shepherds. You won't have his business again. Shame on you!

Do not use this Dealership. Broke down on US 31 and had my Corvette towed to Shepherds . Took 3…read moreweeks to fix it. 3 wrong Fuel pumps later and the car was fixed. Picked it up and drove it back to South Bend and the car died in my warehouse parking lot. Had it towed again and all the car needed was a tune up. Spark plugs and wires. Talked to the owner of Shepherd's and he could have cared less of the issue his company neglected to take care of. Would not even give me his GM's contact info. Told me to " look it up". The top of there invoice says " If your not completely satisfied, we will correct it". Sad Dealership to say the least

Customer service here is terrible and had declined 100% in the last few years. I'm only giving this…read more2 stars because of how amazing Steve is and the sales team is. But everything else is just trash. I purchased a brand new boat last summer. I took it got to be winterized and to warranty fix my boat cover that started to tear. I picked it up and the fall afterwards and didn't look too closely. They fixed the button but not the tear. They also left greasy dirty hand prints and dirty foot prints all over my boat that were such a pain to clean up. I didn't notice the tear was till there until I pulled it out of storage. My fault for not looking at it when I picked it up in the fall. I had it brought back to fix the tear. They fixed it but they left my boat outside in the rain. To fix the cover. A bird took a crap on the back seat. They then didn't put one pole in and put another pole so tight they couldn't snap all the buttons and now another button is tearing because of it. I went to clean the bird poop off and it left behind a yellow stain that I have no idea how to get off now. Also when I picked up the bait my 7 by 5 pin adapter is no longer connected to the boat which I always leave connected. They also winterized my waverunner and when they disconnected the negative terminal from the battery they did not put the screw back in so I had to go find a new screw. They do not care about your property. I would not recommend you use them to take care of yours.

I bought a 2006 Mastercraft boat in February 2025, which seemed great at first--new motor, low…read morehours (approx. under 200), and factory ballast tanks. But after storing it at the marina prior to picking up for the first time, I found the trailer's guide poles missing, and while the sales team couldn't help, I replaced them myself. These guide poles are unique to MasterCraft trailers. When I tried towing, the trailer wiring was faulty. I fixed the ground wire and got it working. I launched the boat at my local dock, but on the first outing, the bilge pump started working overtime. I discovered the leak was from a wire running out of the transom. It took nearly four weeks as it was busy season starting the summer to get the boat into service for the local marina to fix it. Once back in the water, I found additional issues of two unsealed seacocks causing leaks, which I fixed with marine sealant. However, water kept accumulating in the bilge, and the battery alarm went off after an hour. The port ballast pump also didn't work. I took the boat back to the local marina, who later found an inboard shaft leak, a bad alternator, and faulty ballast wiring. By this point, I was frustrated--my family had only used the boat three times having to pull it out of water each run, and I'd missed great weather. Culver Portside Marina had assured me the boat was "water-ready," but they admitted it wasn't tested before sale when contacting them on the most current 3 issues being repaired and my experience so far. They offered no help with the repairs, despite me asking for at least 50% of the repair costs. The sale was "as is," per the owner of Culver Portside but these issues should've been addressed before posting sale or disclosed during the sale had it properly been tested Now we have a $1,300 repair estimate immediately after the purchase . I'd recommend anyone buying from Culver Portside ensure a thorough documented inspection and test everything before purchase, especially since it's mid-July, and I'm still waiting for repairs to finish. With school starting soon, it's tough explaining the situation to kids who were once excited upon hearing of the purchase. This was a boat they claimed to have been serviced by them the past few years.

I wish all car service places were like this place. This a…read moreplace you can trust, Kevin is one of the best people you can ever meet, meets his promises and very honest. Kevin told me exactly what to expect and fulfilled his promise. They work with major dealers, so basically you can save a lot by going straight to them.

Had a minor dent on my 2019 Honda CR-V and Kevin Carr did a fabulous job! I know where the dent…read morewas, but can't tell - the work was flawless! Had a couple of 'bigger issues' on the front driver's fender and rear deck lid and Kevin made all of that disappear!! Kevon's attention to detail and commitment to "doing it right" is beyond compare. Great work by great people! You cannot find a better option for paintless dent repair!

Great value and quality workmanship. Kept my car clean, too. Local is best! Thanks guys!read more

This is an excellent shop that was kind enough to squeeze us in for an alternator replacement after…read morebeing stranded the night before. I can't thank them enough for their help. Strongly recommended for anyone in the area. Thanks again!